Secure Shell
Problem using Plink remote commands Oct 29 2010 11:57PM
longordercook triad rr com (2 replies)
Re: Problem using Plink remote commands Oct 31 2010 11:47PM
Adrian J Milanoski (amilanoski gmail com)
Hey,

Yeah not sure if this is the write place but i've had similar issues
with plink. Try instead of using the -m flag to not use it but merely

plink blah@ip < cmds.txt

See if that works. Good luck!

Thanks,
Adrian
_________________
Sent from my iPhone

On 2010-10-29, at 7:57 PM, <longordercook (at) triad.rr (dot) com [email concealed]> wrote:

> I'm not sure this is the right place for this, but there doesn't
> seem to be a place to get help with Plink specifically.
>
> I'm trying to write a batch file that will use Plink to tunnel to
> Server 1 via ssh, then use Plink's remote command function to tunnel
> from Server 1 to Server 2. Here's the code I'm using:
>
> start D:\Temp\plink.exe -A -P [port] -D [host]:[port] [username]@
> [server1] ssh -p [port] [username]@[server2]
>
> I should mention that when I log into Server 1 through Plink and
> then manually enter the ssh command, it works fine. I've tried
> putting the ssh command in quotes and putting it in a separate file
> accessed with the -m flag, but the batch file always opens a window
> that says "Warning: Permanently added '[server2]' <RSA> to the list
> of known hosts" and then hangs.
>
> I'm completely and utterly baffled. Any ideas?
>
> Erin
>
>

[ reply ]
Re: Problem using Plink remote commands Oct 31 2010 10:41PM
Saif El Sherei (SSherei npcegypt com)


 

Privacy Statement
Copyright 2010, SecurityFocus