CEMW> Another bit of warning about linksys and their inability to get the firmware
CEMW> release vs. hardware version worked out correctly. If you install the
CEMW> latest WAP54G firmware update for the v2 hardware on v1 or v1.1 hardware
CEMW> (which the readme says is supported)... Expect the ethernet port to disable
CEMW> itself (due to the order in which the interfaces are initialized on the
CEMW> device) after you power cycle it...
From the readme.txt
"
Note: If you try and upgrade an older unit to firmware 2.07 without upgrading
the firmware to 1.09.1 prior to upgrade, you may damage the Access
Point."
This document explains how to upgrade your WAP54G to firmware version 2.07.01
The procedure applies to V1.0 and V1.1 hardwares.
http://www.linksys.com/download/vertxt/WAP54GupgradeprocedureV2.doc
7. juni 2004, 18:56:18, you wrote:
CEMW> Another bit of warning about linksys and their inability to get the firmware
CEMW> release vs. hardware version worked out correctly. If you install the
CEMW> latest WAP54G firmware update for the v2 hardware on v1 or v1.1 hardware
CEMW> (which the readme says is supported)... Expect the ethernet port to disable
CEMW> itself (due to the order in which the interfaces are initialized on the
CEMW> device) after you power cycle it...
From the readme.txt
"
Note: If you try and upgrade an older unit to firmware 2.07 without upgrading
the firmware to 1.09.1 prior to upgrade, you may damage the Access
Point."
Checkout these links
http://www.linksys.com/international/firmware.asp?intfwid=9&coid=48
This document explains how to upgrade your WAP54G to firmware version 2.07.01
The procedure applies to V1.0 and V1.1 hardwares.
http://www.linksys.com/download/vertxt/WAP54GupgradeprocedureV2.doc
--
Best regards/Venlig hilsen
Richard Bjerregaard
[ reply ]